|
|
Rocket 3
Launch Checklist
Pre Launch
- Check for damage
- Chutes
- Recovery harness
- Airframe
- Computer
- Charge battery
- Prepare Ejection Charges
- Gather Required Items
- Gloves
- Goggles
- Pliers
- Wadding
- Charges
- Igniter
- Motor
Preparation
- Fit
- Check fore body tube fit
- Check aft body tube fit
- Check nose cone fit
- Aft Section
- Insert Motor
- Insert wadding in rear tube
- Roll drogue streamer, insert in rear tube
- Insert wadding over drogue
- Fore Section
- Pack main chute
- Insert in for body tube
- Insert nose cone
- Insert wadding aft of main chute
- Flight Computer
- Remove any charges
- Check Switches
- ARM on
- Power on
- Assert constant error tone
- All off
- Power on
- Assert continuity error tones
- ARM Off
- Power Off
- DON GLOVES AND GOGGLES
- Install charges
- Check Continuity
- Power on
- Assert one slow beep
- Power off
- Assemble
- Insert flight computer fully into fore body tube
- Insert flight computer partially into aft tube
- Insert Igniter
Pad
- Connect ignition leads
- Power ON
- Assert 1 slow beep
- ARM
- Assert 20 long beeps begin
- Seat computer in rear body tube
- Visually check ignition leads
- Wait for fast 1 beep
|
|